Jintropin, Jintropine, Norditropin, Somatropin, SimpleXx, Hygetropin, Humatrope, Norditropin, Nutropin, Biotropin, Zorbtive, Ansomone, Ansomon, Tev-Tropin, Zomacton, Glotropin, Kefei, Kigtropin, Riptropin, Taitropin.
Transparent oily solution.
1 mL contains:
Active substance: Human Growth Hormone 5.3 mg
A synthetic human growth hormone used by athletes in periods before contests because of the low detection risk. It’s formed with recombinant DNA technology. It offers gains in muscular mass and has the ability to burn fat. It also increases bone density and energy levels and enhance the immune system functions.
Is used in medicine for growth hormone treatment and in case of traumas, severe burns, organ transplantations and cancers, promoting protein combination. It is also considered an ideal drug in battle against aging and is used in surgical operations.
4 to 6 IU per day.
2 IU per day.
Varies by injection method.
Very mild in side effects but there may occur headache, nausea, vomiting and edema of ankles. Other occasional side effects: baby naps, carpal tunnel syndrome, water retention, morning aches, acromegal and hypoglycemia.
Not recommended in case of hypersensitivity to the drug or allergic reactions.
There are no registered cases of overdosage.
The length of the cycle is always different and always depend on the goal and on the compounds it is stacked with. An example of 4 – 6 months cycle would be the use of HGH for first three months, combined with Testosterone Cypionate and Tren A 375 after three months and with Anavar in the last month.
Comes in 16iu pre-filled pen (5.3 mg).
Keep cold (+2-+8°C). Protect from light. Keep out of reach of children.
Before injection you will need:
1. GENOTROPIN PEN 5
2. 5 mg two-chamber cartridge of GENOTROPIN
3. 29 gauge (29 G), 30 gauge (30 G), or 31 gauge (31 G) Becton Dickinson pen needle
4. Proper disposal container for used needles
|Figure||Genotropin Instructions for Use|
|1. Remove cap from the front of pen.|
|2. Remove the front part of the pen. Pull out the empty cartridge and discard it.|
|3. Press the releasing button and thus release button for injection.|
|4. By turning against the arrow indicated on the injection button make the pen mechanism to be on its original position until it stops. If you look inside the pen, you can see how the piston plunges into the depths. Then turn the injection button in such a way that the label on the button and the label on pen are aligned.|
|5. Remove the protective pellicle from the needle and attach it to the front of the pen.|
|6. Open the package and take the cartridge. Compare the color of the pen and cartridge. For Genotropin Pen 16 the color is blue.|
|7. Insert the cartridge into the front portion of the pen, so that the compartment containing the powdered growth hormone is directly contiguous to the needle.|
|8. Connect both sides of the pen, holding it with the needle up.|
|9. For the dissolution of the drug carefully turn the pen up and down. In no case do not shake the pen – from that growth hormone may be destroyed. Through the window on the front of the pen, check whether the drug is completely dissolved.|
|10. Remove the inner and outer cap.|
|11. In order to release the air from the cartridge, click on the injection button until it stops.|
|Figure||Before Genotropin Use|
|1. Looking through the window, check, focusing on the scale, if there is sufficient amount of the drug for injection, if the drug is ended – make a replacement cartridge. If the drug is enough – connect the needle to the front of the pen.|
|2. Activate the button for the injection by pressing release button. On the dosing screen appears “00” and continue for 2 minutes and then goes off (if it is necessary, you can re-enable the screen by pressing the injection button, and then release it).|
|3. Enter the appropriate dose by turning the injection button clockwise, as shown in the picture from left. The number of clicks you can see on the dosage screen. Dial the required number of clicks – as you are prescribed. If you set a too high dose – then rotate injection button anti-clockwise until you will see on display the correct dose.|
|4. Subcutaneous injection.|
Remove and discard the needle. Put on pen the front cover.
Put the pen into its case. Store the case in the refrigerator until the next injection.
Genotropin Pen – multi-dose injection system for growth hormone use: Genotropin. Each click by rotating the injection button corresponds to 0.4 IU of Genotropin. Minimum dose – 0.4 IU (1 click), the maximum – 8 IU (20 clicks).
Genotropin Pen is very easy to use and the accompanying instructions will help you with this.
A maximum of 20 clicks can be used to set a dose. Dosing screen shows not more than 20 units, and if a large dose is dialed then occurs leakage of the drug from the injection needle. If this happens, turn the injection button counterclockwise and check the required dose on the screen.
When the cartridge is empty – the injection button can not move anymore in a clockwise direction.
You can not specify a dose greater than that available in the cartridge. You can check the amount of drug in a cartridge and replace it if necessary.
Battery life in the pen – 2 years from the date of use. The symbol “–“ appears when the battery life remains for 1 month. Symbol “bt” appears when the battery is almost exhausted. In all cases Genotropin Pen should be replaced. But even if the screen does not work, the pen can be used by simply counting clicks.
Genotropin Pen does not require any special storage conditions. It should be cleaned with a clean dry cloth. Do not use alcohol or solvents – they may damage the plastic. It should also be protected from electromagnetic radiation and do not use it close to mobile phones.
If the pen is damaged, it can not be used anymore and should be replaced.
1 Ampoule, 1 Vial, 3 Ampoules, 3 Vials, 5 Ampoules, 5 Vials